Issue A CM2000 series circuit monitor is displaying alarm code 47 on the front display. Product Line CM2000 Series Circuit Monitor Environment Onboard Alarms Cause Alarm code 47 is defined as "Suspended Sag/Swell". The alarm is to identify an excessive number of Sag/Swell events being generated on the meter. An "excessive number" of Sag/Swell events is defined as: More than 48 events total from all Sag/Swell Alarms in any 500ms period, or more than 6 events from any single Sag/Swell Alarm in any 500ms period. Alarm code 47 is active when event 47 is true which occurs when register 2038 on the meter is not equal to zero. If the user disables alarm 47 without clearing Register 2038, the alarm will immediately be re-enabled and asserted as true. Resolution To clear alarm 47, write a 0 to register 2038. To learn how to read and write registers using the front panel of the CM2000 series meter, please refer to KB article FA211912. To learn about other CM2000 alarm codes, please refer to the KB article FA218966.

Yes they are have a Network Frequency range of 47 - 63 Hz As shown on attached Data sheet

Issue: ATO system dumps the plant load when on generator power, as the load increases Product Line: Premium PLC Cause: 47 pickup is too low at 2% Resolution: Increase 47 pickup to 6%

Issue: SoMove will not allow the motor current (IN) to be set above 47 amps on an ATS22 soft starter. Product line: Altistart 22 Environment: All *S6U* Models. Cause: Known software bug in SoMove. Resolution: This is a known problem with SoMove software. It has been identified and reported and should be patched out of SoMove in a future SoMove update. Until then, it will be necessary to manually set the rated motor current in the soft starter using the default keypad. This bug only affects the *S6U* version of the soft starter, the *S6* version is not affected.

Issue: A customer wants to use 2-hole lugs on the ground bar Product Line: NetShelter Bus Bar Environment: AR8395 Cause: Grounding / bonding is required Resolution: The AR8395 has the following holes available: 47 holes threaded #10-32, spaced 18 cm center to center. 25 holes at 5.5 cm and 9 holes at 7.9 cm, spaced at 25 cm center to center.

XUY40327350 is a high temperature fiber specially manufactured for one of our customer (exclusive sales), so to get this product or informations about it, you have to contact directly the company : we are not authorized to provide any information about this product. For further information please visit https://www.schneider-electric.com.au